Wood sliding closet doors – The first step in the task is to measure the height of the cabinet and subtract 40 mm so that the lanes enter without problems. We will have to mark the cut lines on the pulling profiles and cut them on them using the jigsaw and an extra-long blade for metal. In order not to grate aluminum we can put protective plastic on the saw blade. The next thing is to measure the width of the gap, divide between 3 which is the number of doors that we are going to install and add 3 or 4 centimeters for the doors to overlap. Once we have cut the profiles in H and the closures to measure we will have to insert the panels of melamine agglomerate in the pieces of union. We will do this with the aid of a rubber mallet. Finally we will connect the upper and lower profiles.
The next step make wood sliding closet doors will be to place the puller profiles and fix them with the screws that includes the kit itself. To introduce them, we will use the screw drill provided with a tip that is adequate for the size and shape of the screw head. We will then have to cut the upper and lower rails to measure and drill the fixing holes. Then the drill bit must be replaced by a countersink and the holes must be drilled to slightly wear the area and ensure that the screw heads are properly recessed. With the rails ready we have to present the lower guide on the ground and screw it. Exactly the same is what we will have to do with the upper lane.
Then we have to fit the bezel in the lower guide, pressing lightly with the hand, in order to cover the screws and prevent the lane from being filled with dust and dirt. Once these tasks are done, it is time to make some guide holes with a thin wood bit and insert the lag screws. To finish make wood sliding closet doors, the next thing is to insert some decorative brushes into the decorative profiles. Once done, it is time to fit the doors into the lanes.