Invisible door hinges – Consider using invisible hinges if you have chosen a slim set of cabinets to match the aesthetic design of your kitchen, but you are worried about ugly hinges breaking up the look of the room. Invisible hinges are discreet and hidden from the view. They will not interrupt the flow of space outside the cabinet. Read on for a short how-to guide on installing invisible hinges in your kitchen cabinets. If your freezer is already fully fitted, gently remove the doors by turning the hinges and discarding them. If you install a new door, skip this step and proceed. With the cabinet door turned off, measure the width of the door relative to the width of the cabinet to get an idea of what the overlap is.
Also measure the height of the opening. This is important because it tells you exactly how to put the hinges so that your closet closes properly. The hinges must be placed to the far left edge of the cabinet base, 2 to 4 inches above the bottom and below the top. Make a mark of this measure on the cabinet side. With the cabinet invisible door hinges area marked, use the template to correctly notify where the door hinges should go. Then use your drill to drill holes where the freezer hinge holders will go. It’s the same distance you’ve selected in the previous step, even though you can mark it once again to make sure it will line as well. You can then fasten 2-piece invisible hinges by screwing the fastening screws with the Philips screwdriver.
Before attaching the door to hinged pieces mounted in the cabinet, attach the other part of both the invisible door hinges to the door itself. Make sure that the hinged marks are the same, and then measure the same distance on the door and mark where the hinges will have to line up. Then screw in the other part of the hinges to their place on the closet door itself. This can typically be done with just a screwdriver and does not require drilling. Finally, mount the door on the cabinet by connecting the cabinet mounting bracket with hinged piece as you fastened to the side of the cabinet. Make sure all the pieces are connected correctly, so check to make sure that the cabinet door will fully open and close without any problems. If this does not happen, it may be necessary to remove the door and continue adjusting the hinges.