Barn door window covering provide a good way to update the look of your garage door. The window inserts are made of plastic and are mounted inside the window frame between the glass and the frame. Haas, like many other manufacturers, offers a wide range of inserts for typical grid inserts to make designs for the sunset. Installation of window inserts for garage doors Haas requires an assistant. Your assistant secures the external structure stays in place while removing the frame inside the garage door. Consult your assistant to stay outside of the Haas door and keep the outside window frame. This prevents the outer frame from falling off the door when the retainers are removed.
Insert a small flat-blade screwdriver into the left corner of the mount retainers inside. Slide the screwdriver under the left retainer and pry the end away from the window frame. Once you can grasp the end of the retainer with your fingers, slowly pull it out of the barn door window covering completely. Remove the retainer on the right side and the lower retainer in the same way. Once the bottom side and retainers are outside the window, lift one end of the top retainer. Hold the center of the cup with one hand and pull the upper stopper out from the window frame with your free hand. Gently pull the glass from the window frame.
Place the barn door window covering while your assistant continues to hold the outside of the frame. Place the glass back into the window frame on the back of the insert. Hold the glass in place with one hand and press the top retainer into place on top of the frame. Press the retainer with your finger until the edge of the retainer extends over the glass. Install the remaining three retainers, as did the upper retainer. Tap the top of the four detentes with a rubber hammer to ensure that each is secure to the frame. The edges of the retaining elements should be slightly distributed on the glass to provide a secure hold. Repeat the process for all the windows in the Haas garage door.