How To Install A Pocket Door Pulls

Antique Pocket Door Pulls

Pocket door pulls – Pocket doors are a popular type of door for closets and bathrooms. The last step in performing a pocket door installation is by mounting the door pull, which consists of an edge flush flap pulling the pocket door and a finger groove on each side used to push the door closed. Pocket door handles come in a range of finishes, as well as block and step types, but the basic installation procedure is the same and ensures proper door operation.

How to install a pocket door pulls. Mark a line at the front edge of the pocket door at 36 inches from the finished floor surface, and use a square hand to extend the line through the edge of the door. Place the cutting template provided with the pocket door flap against the edge of the door, centered on the line marked. To install a pocket door pulls use a punch to mark the inside corners of the template cut line on the face of the door. The opposite side of the door. Use a hand square to attach a vertical pencil line to the inner corner points of the notches marked, and then mark a horizontal square line from the corner points to the edge of the door on both sides of the door.

Then to install a pocket door pulls. The pencil lines marked with a knife to cut through the surface of the door to about 1/8 of an inch. This will help prevent the surface of the door from splintering when the notch in the door is cut off. Cut off the edge of the door with a jigsaw, making sure to keep the blade inside the lines marked in step 5 to minimize chipping of the door surface. And then to install a pocket door pulls, insert the pocket door disassembly assembly into the slot until the traction edge is flush with the edge surface of the door. Make sure the pivots of the lever pull the top. Secure the pull to the door with the two wood screws provided.

Comments are closed.