Sliding door track hardware – A sliding wardrobe door adds style to your home and saves space because it does not need space to swing. Determining a sliding wardrobe door is quite challenging as it means getting access to a hidden part of the door, however, can repair your sliding pocket door easily, controlled by a set of simple instructions and with the right tools and materials. Use knife to remove paint and seal along the stop in door posts with chisel and kofot, remove stops from their position Center door doorway, lean toward the room and lift away the overlying track.
Locate the door frame and mark the top to avoid drilling into the frame. Place the drill against the wall to determine the space where you will use it. Ground below the drill and on both sides. Drill through the selected area and remove it from the wall to help access the track. Make sure the new door groove is the same length and width as the old Make sure the door frame is level before installing the new track. If not, insert a spacer on the far side of the door frame. Place new door companies on the tracks. Install horizontal sliding door track hardware with screws and move on to the bottom groove that prevents the door from jumping out while you leave.
With the slots in place, remove the old hardware from the door Replace it with the new slabs that secure the door to the slots Lift the door, mount it on the fixed slots that start with the overlap track, and let it fall steadily on the bottom sliding door track hardware. Slide the door and back to make sure it is in place. After successfully stuck your sliding pocket door groove, repair the part of the wall where you drilled to access the web. Clean the holes by removing any debris then take the plaster plaster and fill the holes on the wall using the flap. Smooth the surface for to level it with the rest of the wall Let it dry Take sandpaper and level the area then paint with a paint that best matches the rest of the wall and allow it to dry as well.