How To Build Sliding Door Cabinet

DIY Sliding Door Cabinet Ideas

Sliding door cabinet – Sliding doors make opening cabinets in as small a space as possible. Ball bearing tracks reduce friction. The double tracks for the doors are installed at the top and bottom of the cabinet. The lower set has ball bearings. When installing sliding wardrobe doors, it needs sufficient width to allow two doors to slide over each other.

How to build sliding door cabinet the use of ball bearings. Measure and cut two doors out of wood cabinets to fit inside the cabinet opening, using a hand saw or saw power. You should have enough space at the top and bottom to allow clues. Each cabinet door should be half the width of the cabinet opening so that the two doors closed side by side will completely cover the opening of the cabinet. Place the double roof rail on the top inner edge of the cabinet, near the opening. Holes for wood screws through the holes in the track. Screw the wood screws into the holes you have made to attach the top rail. Place the double bottom rail along the lower inner edge of the cabinet, near the opening.

Then to build sliding door cabinet the use of ball bearings. Holes for the screws that enter the double bottom track. Move the bearings on the track as necessary to access the screw holes. The lower rail should be directly under the top rail to ensure that the cabinet doors are up and down. Tilt one of the two closet doors in the back row of the top rail, and position the bottom of the door in the back row of the lower track. Tilt the second door on the front runner of the top rail, and position the bottom of the door on the lower two way track way. Close the doors so one cabinet door is to the left and the other cabinet door are to the right. And then your wood screws should be just long enough to enter the closet without showing on the other side. For example, if the top and bottom of your cabinet is half an inch thick, use wood screws that are three-eighths of an inch long.

Comments are closed.