Hanging Rustic Barn Door Pulls

DIY Rustic Barn Door Pulls

Rustic barn door pulls – Hanging a door takes a bit of finesse but it is a rewarding task when completed satisfactorily. Barn doors, as in this case, often feature a set of two swinging doors that meet in the center. Try to plan the work so you can take your time and do not get distracted or interrupted. And keep in mind that there are always ways to make corrections along the way. Place wood/shingle wedges on the surface of the floor or the ground below where one of the two doors hang when in the closed position. Place the appropriate door in this middle of the opening, resting on the wedges.

Replace the wedges, as necessary, by sliding them in or out of a greater or lesser thickness to raise or lower the door. Have a helper hold the door in place or screw a piece of waste wood temporarily to the outside above, which extends down over the top of the door to keep the door from falling outward. There should be a stop of permanent door around the interior that rustic barn door pulls with the outside, preventing it from falling inside when closed. Now you are ready to fix the hinges but if belt hinges are simply connected and the shims removed, the weight of the door can make it slump lower than the desired position.

To compensate for this, run masonry rope through the outermost screw or Bold hole in the strap, doubling, tripling or quadrupling the rope to achieve the necessary force. With the hinge as close to flat against the door as possible, rustic barn door pulls down on the hinge with the string, simulating some weight of the door. While holding the tension in the rope, drive the screws or stay in all, but the outermost hole in which the thread will be, then relax and remove the thread.Now install the end screw or stay bolt for that hinge. Repeat steps 4 and 5 for the remaining hinge or depends on this door. Repeat steps 1 to 6 for the other door.

Comments are closed.