Hanging Curtains For Sliding Doors

Curtains For Sliding Doors Patio

Curtains for sliding doors – A directed moving curtains and rods are designed for sliding glass doors. A one-way curtain opens in the same direction as sliding glass door, allowing you to control the amount of light and access you prefer. You can open and close the curtain from a cord mounted on the side of the curtain. The entire curtain opens on a track; and when mounted correctly, the curtain allows the entire window area to be exposed so that the doors are completely functional and attractive. Measure the width of sliding glass door. Install the crossbar system 4 or more inches above the door liner. Use smaller screws supplied with the system and wall anchor if there are no wall controls where you need to mount your brackets.

Pull the cord down on the collection side of the door. Install a tension roller provided for place curtains for sliding doors hanging by the traverse system kit to the wall according to special instructions from the manufacturer. In general, the truss brackets above the hemisphere are the height of draping and behind the outer edge of the curtain. The cord should be vertical from the pole to the pulley. Pull the cord so that the main cylinder and arm are in the closed position. This places the arm above the handle on the glass sliding door. Insert drapery pins on the back center of your drapery fold so that the upper hook of the pin is an inch from the top of the bed sheet.

Place the drapery of curtains for sliding doors with the decorator fabric in the room. If your sliding door is on the right side, your first drapery pin will be stapled to the far right. If your door handle is on the left side, your first pin will be pinched to the left. Hook the adjacent, or other, stapled into the third hole of the main cylinder arm. This means that you skip the other hole in the arm of this installation. Hook the third pin into the last hole of the main cylinder. The main cylinder is a rectangular white plastic box that controls the opening and closing of drapes. Hook the next staple into the first small plastic glass. Continue chop each staple into a picture until you have two drapery pins left. Insert the pencil on the face of the corner bracket. Put your last pin around the corner of the bracket near the wall.

Comments are closed.